|
Northwest Illinois | Bought a used daycab t600 that has these fairings coming off back of cab. It is an aerodyne cab converted to daycab and I believe these fairings were installed then because it's the stock location for the exhaust. I want to remove them. The easy part is removing but was questioning the replacement of the new rivets. The rivets are solid aluminum round head. I believe these are installed with an air huck riveting gun with interior out and a hammer on the back. Am I wrong or how is this done. The rivets are factory location and was wondering if a blind pop rivet would be a good enough replacement. Basically don't want to buy a special gun for solid rivets or remove interior. | |
|
Rivets on kenworth cab
