|
Missouri | No. The PMM is just a short (foot or less) cable that plugs into the PMM and has three ports on it. Power (obvious), CANbus (communication to display), and muxbus (serial communication to sensor harness).
The sensor harness is plugged into the planter harness at the hydraulic block on the toolbar, to the right of the center post tube. (i.e. the "main" hydraulic block). It is a 3 pin weatherpack harness underneath the block with black, white, and green wires. You will need to unplug the sensor harness from there, and plug it into the PMM cable instead. There is a programming process that is necessary for the PMM to learn each sensors physical location, and all sensors must be disconnected to begin this process, so I would do that at the same time as changing the harness around. If the planter has any age to it at all, be careful with the connectors. If they've seen much UV exposure, the locking tabs on the connector shells will break easily if not handled gently.
| |
|
Replace KPMII with Integra
