Posted 1/7/2014 15:31 (#3583588 - in reply to #3583504) Subject: Re: Need ideas on how to take out dents in auger tube
West Ky
We dented the auger on a grain cart and we put in a hydraulic jack in it and worked it out so smooth you can not even tell where the dent was even at. It was a good sized dent too. Think of a way to get something in their to push on it, may have to get a 3/8 piece of steel or bigger and bend it the same way the auger is shaped and push on it on the inside.
Need ideas on how to take out dents in auger tube
