|
Missouri | I don't think there is a way to configure the display for that. offsets are not adjustable on an individual section basis.
Multiple modules are assigned their position by jumper wires in the harness, that tell each module it is the first, second, or third clutch control module. They do not work independently of each other. For example, each module is capable of controlling 12 sections. Two modules work combined together as though they were a single, 24 section module. I cannot think of a way of configuring them for independent operation.
How far apart are the front and rear rows? On Kinze interplant planters, the difference is a little over 5 feet. Splitting the difference, half the rows will skip by about 30 inches, and half will overlap by about 30 inches. Even if an independently clutching front/rear configuration were possible, I don't think the benefits. would offset the cost of a second clutch module. | |
|
What do I need
