Ayr Queensland Australia 4807 | Did you have lever 31 off valve 25 have seen this before when its on full flow their is no flow.
You have covered most other items cam position and direction , how about the valve roller sitting on the cams ,are the cams sitting up straight and against the adjusting screws ensure the cam retaining screws are finger tight and witha smal screw driver lever the lighly up against the adjust screws then nip the cam retaining scews . Does the tractor hitch work , pat may have said about the orings on the two pressure valves ,the cam carrier should sit level with the housing face when in neutral .
My bet is on the flow control if you had the roll pin out
Edited by KelB 4/12/2008 02:24
Attachments
----------------
 scv.mht (39KB - 280 downloads)
|
SCV adjustment
