KMech,

Thanks a lot for the reply I really appreciate it!

I wonder if you go to trick the system by putting entering it as a 3660 if it is going to have an option for no HYD drive since HYD drive is the only way that a 3660 can be equipped?

I have been looking at the ISOBUS Electric Clutch Package wiring harness diagram for a 3660 online. I was wondering if the Jumpstart cables that hook back into the sensor harness were only necessary on VR planter? For some reason I've got in my head that Jumpstart has to do with VR. 

Also does the harness that plugs into the sensors through the length of the toolbar have to be replaced to be able to plug into the PPM? 

Would variety tracking be possible? 

We will not be putting clutches on the interplant units.

I didn't realize that you had to use preset profiles for the planter. I was looking through the Kinze Operators Manual on ISOBUS and it has a page that shows how to put in Offsets into the 2630, is that just for side to side offsets?

Here is a link to what I'm talking about: http://www.kinze.com/filesimages/manuals/ISOBUS_M0246_R0813.pdf  (P.23)

Thanks alot for your help!

Eric