PA... close to the Plain Community | In my Trimble Training, we were always told the FM750 won't work with anything less than a full kit with Trimble sensors. We were never really told what would/wouldn't happen if you did. That being said, you said yours WAS working before the welding. I am assuming you are tied into the factory header height sensor with a shorty-harness?
Seeing as how you got that far in your troubleshooting, did you reflash firmware to your YM module? what firmware is on your YM module? What firmware is on your 750? |
Trimble Yield Monitoring-not able to do tare calibration
