Near Intersection of I-35 & I-90 Southern Mn. | KMech - 11/17/2013 05:16
I don't know if I am correct in this statement, but based on the behavior I have observed on the PF3000, Insight, and Integra, I think it is like this:
I think the system records the raw sensor data, and the calibration is what is used to calculate yield data from raw sensor data. I don't think the calibration actually changes any old data, it just changes the way that old data gets calculated into grain flow. Like I said, this is just a theory I have, but the observed behavior of the system fits the theory so far. Feel free to punch a hole in it if you can.
If data is dumped to the card, then read into SMS, then a calibration performed, SMS will update results to the new calibration if you dump to the card and read into SMS again after performaing the calibration.
Yes, I agree. The Raw data is saved to the memory card and the yield is computed later with SMS depending on the cal values that you want it to use. |
Data on cards after calibration??
