Warburg, AB | sf 1066 - 11/10/2013 13:58
Don't need a stand if your just doing axles. Unless you have to go in deep
x2. If you have good solid blocking across the back under the drawbar support, you should be fine. You can make a stand if you want but the iron is wide enough there, I'd lift the tractor until the tires are 1" off the floor, then block them. That way if it did ever try to tip, you've got the tire right there to support you. If you're taking the rim off the center casting, lift the rear in the same manner as suggested, remove both of them, then drop it down lower to the floor. If you're really worried about it moving remove the front tires as well.
Bruce |