|
NE Iowa | Have a customer with a 2013 T8.360 put a Paradyme steering kit on it utilizing the factory WAS. The wheel angle sensor was intermittently working, it would indicate a normal amount of 'counts' as you turned from left to right and then it would stop working showing 0 then once you turned the wheel it would jump to 65,000..
Put a new factory wheel angle sensor on and have the same problem, leaning towards swapping cables next. The wheel angle sensor has a short lead off it than ties into another harness but I'm not sure where it goes from there. Anyone have a wire diagram available? TIA | |
|