|
Carter Montana | You need to unhook bulkhead connector #5 and insert the ag leader harness end. Join the other two ends together. Use electrostatic grease so you can get that bulkhead connector hooked up again and maybe a little WD-40 on the rotating retainer. You don't want to bend a pin over like we did. It's tight up there and hard to see. I think #5 is the left one but can't recall for sure. The instructions are OK for this.
The remote/aim is a toughie as I couldn't tell either. I think you splice into the ones with wires going both ways out.
Edited by mtbrights 10/22/2013 21:53
| |
|
direct command install on case 3330
