roaming | AFS kyle - 10/17/2013 18:35
adjust your header stop height in the ToolBox > Head 1/2 (cant remember which at the moment).
ETA:
What machine are you running? Have you done a header calibration? Are lateral tilt and automatic tilt turned on in Toolbox > Head 1/2? Do you have header sensors enabled in Toolbox > Head 1/2?
Yep, Max Work Height for sure. Toolbox > Head1. This setting is specific to each Crop Type, and you have it set lower for soybeans than what you want for corn, since you don't run the cornhead as low to the ground as your platform. |
Pro 700 not counting acres
