|
| Try raising your record stop height. I have run into some that it is set to low and the recording trips off even though they are still cutting. This locks the "end of cut" but product still hits the mass flow so it keeps counting up bu. I usually have my customers lower to cutting position and then raise up manually 24" and save the stop height there. You can find that by going to Menu/Original Greenstar/Setup/Harvest Monitor. It should be by the "F" button. Take note of the original percent and the new percent when you save. If there is a big difference that may be it. | |
|
Yield doubles on 2630 in a 9660
