|
Sheldon, IA | It will need to be on either channel 1 or 4 in the under the "combine settings" buttun screen.
Home screen, wrench, highlight combine, wrench, combine settings in center pane on screen, header sensor channel, set to channel 1 or 4 and accept it, then go try it, if doesn't work go, repeat steps and try other channel. If still does not work check that header sensor wiring is plugged in tightly. If you call Ag Leader there is an OHM test for the header sensor but I don't remember what pins and what the proper readings should be.
Edited by bpeelen 10/15/2013 11:38
| |
|