|
roaming | Here's an outline
1. Make sure your machine is configured correctly for DGPS guidance (Toolbox > Drives >> Autoguidance Type = DGPS)
2. Turn on GPS and configure (Toolbox > GPS)
3. Turn on the Nav & configure (Toolbox > NAV)
4. Set up your Run screens as desired.
5. Calibrate
5.1 Steering sensor calibration (Calibration > Calibrate >> Rear Wheel Position)
5.2 Dead Zone cal (can't remember if it's in Calibrations > Calibrate, or Calibrations > NAV; it was added fairly recently)
5.3 Roll cal (Calibrations > NAV) | |
|
Case IH 8120 Autosteer set up and calibration.
