|
roaming | you might have 70 loads that you've done through the Wizard, but you only have a maximum of 10 that are actually being used for calibrations. The ones that are set to "YES" are the only ones you need to be concerned with. Go to Calibrations > Moisture (or Yield), then Wizard, then Calibrate. Choose the crop type you're working with, and then you'll see a list of all the Tasks that have been done through the Wizard. The ones that are set to YES are the ones that are actually being used for calibration. Change Tasks from YES to NO or NO to YES as needed, then press the Apply button.
To reset to factory cals, go to Calibrations > Crop, then Import Cal Values From "DEFAULT", and press Import. This will set you back to factory for the selected crop type, and you can now start calibrating from a clean slate. | |
|
torn
