|
Western New York | Softail is right, check the moisture sensor, there should be a little copper colored button under the fin of the sensor. The temperature reading is one of the most important parts of the system. Change the sensor and it should be fine......Don't "F" with that prox screw unless you absolutely have too. I have seen this before and this should correct your issue. just be sure that the new moisture sensor is compatible with what you take out. That sounds like an analog sensor and all the new sensors will be CAN based. make sure before you order that it is compatible or else you will be changing more than just the sensor and the bills will add up! | |
|
Moisture not changing Insight yield monitor
