|
SESD | Have a 6088 with a Pro600 and 372 unlocked to Centerpoint RTX. Running a 30 foot, 3020 flex head and cutting at a slight angle.
How do you guy's setup your Pro600/700 to keep from leaving strips ? I have both my header width and working width set at 30 feet. Do I need to set the working width, the header width or both to something slightly less than 30 feet to avoid leaving occasional strips ? If I travel in one direction it leaves a occasional strip. When I travel the opposite direction it overlaps roughly 6-12 inches. Unit has been calibrated several times and appears to be spot on. Also, it does not appear a header offset is needed.
| |
|