|
| I just did a 9610 last week. You will need 2 , 2.5 volt terminators. One is above the headliner & other is above the moisture sensor. Just follow the wiring harness , you'll come across it. Now,, if they are white, your good,, those are 2.5 volt,,, if they are black, those are 4.5 volt
I still have the box w/ part number for the wiring harness to change out in cab. It's not very long ,, you just unplug the one & plug it back in. If you have a wedge box behind the seat, just unplug it.
You will also need a new circuit board in your moisture sensor.
Then you will need the software to reprogram the circuit board. That you will have to do with a brown box & mobile processor.
Hook up your ATU & a 2600 or 2630 & you can steer & map to your hearts content.
This sounds ALOT harder than it is,,, really.
I will post the part number & software version tomorrow.
Where are you located? I can assist you with this project if your not to far from me | |
|