|
Eastern Nebraska | I would set up a page with your yield on top and your totals on bottom. Set up your mapping to show yield by going to menu, GS2, mapping, then push map settings at the bottom and set foreground to yield then hit accept. Then back on the mapping button there's a button with a blue square and a multicolored square so push that. When you do a box will appear on the left side of the mapping screen that will show 5 colors. Hit it and set your max and min. Make sure your min isn't 0. It will show yield and moisture on the 2600. The command center will show moisture. The combine should know when you plug your platform into the single point that it's a platform and it's 30ft.
For the second comment, keep in mind that the AutoTrac activation is stored in the display. If you were AutoTrac'ing with the tractor you'll need to move that display to the combine if you want to AutoTrac unless you buy another activation for the display in the combine. AutoTrac SF1 and SF2 work with receiver signal SF1 or SF2. You can't have SF2 receiver signal and run AutoTrac SF1.
Hope all of that helps. Now go harvest :-).
Edited by PrecisionNE 9/26/2013 11:33
| |
|