|
Vincennes, IN | Fuse is good and auger is turning both when the clean out button is pushed and when I waved a screw driver around inside after removing the sensor. I pulled the sensor and wire harness off and the wire and connections all look good. It was the power/ground wire that I had taped the jacket back up on last fall, so that's not it. Is this sensor what you are referring to as the elevator mount moisture module? Is the relay contained within it or someplace else? Thanks -Matt
Edited by mhalter 9/21/2013 14:50
| |
|
YM2000 Moisture Trouble. Sensor or wire?
