|
Bancroft IA | Jut installed a Trimble Autopilot system with an FMX display in JD 8360R. Installed the CAN unlock code on the JD monitor. I am then to go in the JD monitor into the message center to XMC and XSC as part of the calibration process to specific addresses. However, the monitor only goes up to XMB and XSB. I have verified the JD equipment has all the latest firmware. I have actually had the tractor auto steering with the FMX but cannot get into those areas to perform the fine tuning of the calibration. Any ideas what I need to do to get those items to populate in the message center.
TIA | |
|
JD 8360R and Trimble Autopilot
