|
roaming | hmmm, odd. It's not unusual for accuracy to vary as your flow rate gets farther (lower or higher) from the calibration point, but if the flow rate is staying consistent, I can't think of any good reason that your accuracy would change. Especially when it only happens in one Crop Type.
The NH yield monitor system uses the same base cal values for almost all small grains, so it would be interesting to try using, say, Flax, as the Crop Type for some canola. Calibrate and harvest canola as usual, but with the Crop Type set to Flax. See if the problem continues, or if it goes away. | |
|