|
NW Ohio | I had a little time to mess with stuff tonight. If I unhooked the ISO coupler from the seeder (seedstar 1), the whisker switch works like it should. There is "com port" button in the lower left of the screen that is greyed out. In the equipment tab, while the switch worked properly, I plugged in the ISO drill harness. It changed to "Auto" and greyed out. At the same time, the "port com" button un-greyed, allowing me to go into it. I'm assuming that something needs done in it? I did not see anything in the operator's manual on this button. I can pick connections "1" or "2". Then I can pick a port: Serial, Field Doc Connect, In cab Printer, N-Sensing, Follow Track, Innoculants dosing. Any ideas? TIA | |
|