|
Minnesota | Have you tried doing a wheel angle sensor Calibration. From the Main screen hit the calibration button-> make sure your on the calibrations tab on the bottom. Should get a white box that is selectable on the top part of the screen. Hit that and it should give you a list of calibrations available, one should say wheel angle or rear wheel position or something along that effect. Select that, and follow the on screen for calibration. I have had more then a few combines that will drive straight but stay offline 12-15inches left or right until that cal was completely (never 100" off but you never know). Just an idea if everything else seems to be working, heading matches pretty close, and not getting error codes. | |
|
Omnistar XP and G2 in the same field
