|
Ontario Canada | 7800 is wired different than 7210. Have to decide on that 7210 if you want a full ISO harness or not. You can get by with a mobile harness PF90463 if you don't plan on running anything requiring an ISO plug at the back of the tractor. This PF90463 has the original GS two plug config. You need PF90688 to adapt to GS2 or GS3 screens. This PF90463 harness is cheap and simple for an ATU or ATU 200 wheel. They plug together with no additional inline ISO adapter harness. Not too bad a job to hide the wire up cornerpost to roof. Have to lift roof off, and remove cornerpost. You always require keyed power and live power, so easiest is to use the round three prong auxiliary power outlet. Next trick is to see if there is a factory greenstar ready starfire receiver mount for at the front of the cab, so then you won't have to use the bar mount across the center of the roof. Check with your local JD dealer. The full Greenstar Ready ISO kit is around $1200. You need the ISO kit to run a JD rate controller or Seedstar 2.5v planter etc. This harness is quite bulky and harder to hide. It does let you hook up an implement switch and ground radar easier. The ISO harness also has the wide connector to tie into the tractor bus wiring on the large frame 7000's. That's what let's the display see the state of the electric remotes and pto etc. - Daver
Edited by GreenDaver 9/4/2013 16:27
| |
|
Greenstar ready kit on a JD 7210
