braidy - 8/9/2013 07:32 I would dump the 7/16 and 9/16 not very common. Then add in 1/4 length increments from 1/4" to 3/8". Start the same sizes at 1/2" long also. Ours jumps in 1/2" and it seems they are always too long or just a hair short. I agree on dropping the 9/16" but keep the 7/16" if you run any older equipment. LOTS of 7/16" on older JD and IH machines. Plus they are hard to find in my area if you need them. | 
Bolt Bin Layout?
