Appomattox/Fredericksburg, VA | +1 on the meter. If I remember correctly on the wires; power, ground, and signal. Power should be 5v and 2.5 for the signal wire I believe. I'm shooting from the hip here. Which combine is this on? Check your connection at the moisture sensor if it's on the clean grain elevator. My head is cloudy tonight but that connection has posed problems in the past. I found on our 9550 the wires had been apart in the harness about 2 feet back around the grain tank from the mass flow sensor. I had run 3 wires for 970, 971, and 972 direct from the mass flow down to the moisture sensor to find this. If you look in the display you can check the diagnostics. If you look at the mass flow you should have a raw flow and zero flow (I think it is). If you don't have a reading there it might help you out. I have the DTAC case in our combine I'll have to dig it up if I get a chance. Sorry for the ramble. |
john derre brown box problems
