|
roaming | the only one I can think of would be the Flow Sensor Cal Number, which is required for accurate calibrations. You can copy it out of the old display, or get the number off the sticker on the flow sensor, if it's still readable. In my experience, the display will often autodetect the number, but not always.
Everything else is pretty straightforward; after you get the 600 installed, go to the Toolbox and run through each screen to complete all setups. Then go to Performance > Profile to create your Growers, Farms, and Fields (or better, export them from the desktop software to your datacard, and they'll be imported automatically when you power up the display). Other than calibrations, that's pretty much all there is to it. | |
|
Advice for upgrading yield monitor from UD - Pro600
