|
EC Alberta | Hey guys
I have the new SmartSteer software (6.0.17) unzipped on a memory stick, the problem is I can't remember the steps to proceed with the install. If memory serves me correct: With the key off, insert memory stick into USB
Turn key on, but don't start the engine
Power up screen and follow the prompts. (should take around 15 minutes)
I'm pretty sure that is correct, but I'd like to see if anyone could confirm that or otherwise.
I printed off the instruction that came with the software download, but I found them a bit confusing, the last time I did this was 2 1/2 years ago and I cant quite recall exactly how I did it.
-Secondly has anyone updated to this version?
-How is it overall?
-How does the new 180 deg. 3D calibration seem?
-I'm planning on writing down all of the measurements, settings, and implement profiles beforehand, is this all necessary?
All advice is appreciated
Thanks | |
|
Raven E-Pro 2 & SmartSteer Software Update
