|
East Central Indiana | Ex-Cat,
Your receiver is new enough you might not have to run a new wire. I think this might work for you. If you have a newer Deere GreenStar harness in your Quadtrac, probably somewhere in the mess of wires in the cab there are 2 brown single wires with the same single pin connectors. These should be close to the 2 pin and 4 pin deutch connectors that connect the GS harness to the implement connector harness. More than likely the one marked Radar w/R printed after wire # is plugged in and the one marked GPS w/G after # is capped off. You need to move/swap those so the one marked GPS is plugged in and the one marked Radar is capped off. Then go into your display and hit "Menu", then "Performance Monitor", then the setup button on the left hand side (arrow and dot). You should see an option that you can check mark to the effect "GPS or Radar connected to display". (This may only need to be done in a 2600). Then go into the planter icon and the planter setup button and under the sensor tab in the drop down list choose "Speed Source" (or similar) and choose the icon that looks like a radar and says GPS. This should work for you. | |
|
Anyone running JD AutoTrac in Quadtrac
