|
| If you are using Field IQ, that will switch coverage On & Off Automatically, so the Coverage Logging Config won't be shown in the Implement setup. Your initial post said that you were using an older style planter with no electronics on it? Are you actually using Field IQ to control this Planter, or is it set up on your system for another machine? If you aren't using it to control this planter, then make sure you have removed the Field IQ from that Implement. To check this, in the Config screen, under your implement name, Field IQ will be displayed. Press Add/Remove, down the lower left corner of the screen. Highlight Field IQ in the right column, then press Remove. Now you can go back into the Implement Setup Screen and select Extras. You will have 2 options- Variety Setup or Remote Log Switch. The Remote Log Switch will have 3 options - Disabled, Port A and Port B. When you have selected either of these ports, another option "Logging When" Appears. The options here are either Low or High. This is used to change the logging when the Switch Contacts are either Open or Closed. Hope this helps. | |
|
Trimble FMX (FM1000) Implement Switch Installation
