|
Troy, Missouri | I haven't messed with one of the Seed Commands yet, but I don't wonder if it could be a similar problem that a customer here had with his OnTrac2+ steering unit: Every time he does and turns the monitor on first, then turns the tractor on, it sends a power surge and resets the guidance. So, when he goes through the operation setup and then to his run-screen, the little steering wheel is missing in the bottom right corner. If you go into the steering and guidance settings on the monitor, under guidance it has switched back to "Manual Guidance" instead of being on "OnTrac2+ (CAN A)" like it should be. Not sure if that could be a similar problem for you but it might be worth checking in to on the Seed Command settings. | |
|
Integra VT and 1770 NT Help
