|
Maryland | I am running a fm750 with full autosteer pulling a planter. Short of getting a fm1000 and running another setup on the planter what can I do to fine tune the way the planter pulls. I have the right to left set up right and have been playing with the hitch to contact point length. Is there anything else I can play with to get it to work any better. Not sure if there is an antenna to hitch point setting I can tweak or is it just not possible to get it right on. Some turns it seems to go a little wide around the outside and a little close around the inside of the turn | |
|
Fine tuning Trimble Autosteer
