|
Boulder, Colorado | I'm not sure what Raven has in their installation manual for the port settings in AgRemote, but if you are using RTK link, try CMR, and if you are using CMR try RTK link. (I'm not sure what the difference is, but sometimes that will do the trick.)
Also, double check you baud rate, make sure that the FMX is set to Trimble CMR radio. If none of the above work, try clearing the BBRam in the FMX and start over.
This is what I would do if this were an Intuicom Bridge, but someone familiar with Raven may have some other suggestions.
Hope this helps
Andrew | |
|
Raven Slingshot not communicating with FM1000
