|
NW, OH (Wauseon) | I disagree with Tim, and this is why, if you only use the two ports on the three port flow control, when u block the ef port, the tractor remote valve is set at 1/3 flow or 35% let's say around 10 gpm. If that amount of oil doesn't get out the remote and through your flow control, it is going to push as hard as it can to send 10 gpm of oil out. the system will go to maximum pump pressure and stay there until u open up your new flow control to let the oil flow to your winch valve. So really you should hook it up as u would an open center system.
Now, on the other hand if u hook it up to your power beyond, that's a different story. Then use it as a two port flow limiter, and Hook in a load sense line after the flow control and before the winch valve.
| |
|
Plumbing hydraulic flow control and spool control valve to orbit motor?
