Dallas Center IA 515-720-2463 | Very easy to do.
You do not need to go to your dealer. Except for a hose and hydraulic couplier, but a farm store will do.
This will work on White model 2-85, 2-88, 2-105, 2-110, 2-135, 2-150, 2-155, 2-180, 4-150, 4-175, 4-180, 4-210 and 4-225.
Also Oliver 1755, 1855, 1955 and 2255.
Also some M-M and Cockshutt models of the same time frame as the Oliver models.
Top picture.
On the end plate of the stack of hydraulic valves - At the top is a pipe plug with that a allen wrench will fit. Remove this plug.
The hole is 1/4" NPT.
Second picture: Use a 1/4" close nipple, then a bushing or couplier to get it up to 3/8" or better yet 1/2".
From there you are on your own.
In the picture I have a Pioneer male. To use I hooked a female on the male, then a hose to a couplier near the PTO shield.
I have since went to JIC.
Return by removing the pipe plug in the lower left of the rear side of the casting on top of the rear end casting. Picture 3.
Some early, like 1977 model 2-135 and 2-155 tractors do not have this hole and you will have to drill and tap it. Both my 2-135 and 2-155 had to be drilled. But all the later ones have the hole there.
Also both my 2-105 and Oliver 2255 had the hole in place.
Edited by Bobby Greif 3/11/2013 08:48
 (DSCF0107 (2).jpg)
 (DSCF0110 (2).jpg)
 (DSC01614.jpg)
Attachments
----------------
 DSCF0107 (2).jpg (57KB - 785 downloads)
DSCF0110 (2).jpg (56KB - 818 downloads)
DSC01614.jpg (55KB - 785 downloads)
|
White 2-155 Tractor Experts
