|
Almond Wisconsin | Dt 466 is the easiest inframe there is. I have done many in my farm shop. Definatly do the pan drop pressure test and see which hole is leaking. If it is pushing out on the outside of the liner you can get buy pulling it down changing rods and mains, new O-rings on all liners and go. Just push liner out from below and leave piston in bore. Make sure to inspect cam lobes and outside of liners for cavitation. If liners show any flaws change out the whole set and get the head done. But if the unit doesn't get alot of miles and is running good you could get by on the cheap. Better put my flame proof undies on because I'm sure it would not be NAT approved! | |
|
dt 466 engine
