|
Westport, IN | I don't have pictures but hopefully I can describe them. If you rarely need stands this idea may work for you. They are bulldog side wind jacks. A flat plate 3/8 thick with holes drilled to match the tractor has a jack mount welded to it. Then they use cribbing (stacked blocks in a pattern to build a stable base) under the jacks. Then use a very good floor jack under the rear of the tractor and roll the rear of the tractor back. I know one time I helped them make a saddle to bolt to the tractor with a post that stuck down to fit in the floor jack where the saddle would normally sit. | |
|
Engine and splitting stand ideas
