|
Osakis, MN | It's really much easier to use than you think. First thing you do turn it on and write all the calibration numbers down if it has them in the memory still, just touch the boom 1 button and that is your first boom section width in inches, now tap each button across that row and write down the numbers. If they aren't there its not too hard to figure out what numbers need to be entered. Now the thing to do is put a fresh battery in the back of it to save the memory so you don't have to enter in the calibration numbers if they get erased from low power. Next turn it on and if it still has its calibration values in it still, write them down on something that is handy and can be left in the sprayer. Once you have the right numbers in the monitor, it's as simple as flipping a switch on and off on the ends of the field. If there are any questions ask away! If it doesn't have any info stored still it will just say CAL in the box when you turn it on. To program the buttons just press one of them, then push enter, type in the number, then hit enter again. http://www.ravenprecision.com/PDF/Manuals/016-0159/822C.pdf
Edited by tomosakis 12/28/2012 08:10
| |
|
Raven 440 controller
