|
Lincoln County. NC | Adjust the knife arm so it clears the billhook by 1/2" at its farthest point in its travel arc. Measure while holding the arm back towards the billhook. The spec is 3/8 to 1/2 and the lower end of the spec will give a shorter tail. Also check to be sure the twine disc timing isn't retarded on that side as compared to the other.
1-1/2 turns on the twine holder tension??? Sounds like you loosened the billhook cam tension. If you actually loosened the twine tension 1-1/2 turns, you are gonna lose the twine from the holder altogether.
Edited by RickB 8/12/2012 05:30
| |
|
- New Holland 273, one knotter leaves tails too short - Orion : 8/11/2012 22:06
- Re: New Holland 273, one knotter leaves tails too short - Badger : 8/11/2012 22:09
- Re: New Holland 273, one knotter leaves tails too short - upstate ny : 8/11/2012 23:15
- RE: New Holland 273, one knotter leaves tails too short - RickB : 8/12/2012 05:30
- RE: New Holland 273, one knotter leaves tails too short - Hay Hud Ohio : 8/12/2012 07:41
- Re: New Holland 273, one knotter leaves tails too short - Orion : 8/12/2012 07:54
- Re: New Holland 273, one knotter leaves tails too short - Orion : 8/12/2012 09:01
- Re: New Holland 273, one knotter leaves tails too short - Orion : 8/12/2012 09:14
- Re: New Holland 273, one knotter leaves tails too short - upstate ny : 8/12/2012 09:35
- Re: New Holland 273, one knotter leaves tails too short - Orion : 8/12/2012 12:10
- Re: New Holland 273, one knotter leaves tails too short - Orion : 8/12/2012 19:07
- RE: New Holland 273, one knotter leaves tails too short - Hay Hud Ohio : 8/12/2012 19:15
|
New Holland 273, one knotter leaves tails too short
