AgTalk Home
AgTalk Home
Search Forums | Classifieds (148) | Skins | Language
You are logged in as a guest. ( logon | register )

856 IH TA Issues
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
TORQUE
Posted 7/7/2012 22:07 (#2472469 - in reply to #2472071)
Subject: RE: 856 IH TA Issues


SC Iowa
If the TA pulls OK in direct and low side of TA it is not out. If by "rolls" you mean it will coast down a hill in low side of TA then the over run clutch pack in the TA is bad, it is still OK to use that way, just use direct when going down hill. Make sure the clutch pedal linkage is adjusted to 1" free travel at the floor board. Then to adjust the TA dump valve linkage, make sure the lube light is on with the clutch pedal down, put tractor in gear and raise pedal slowly, the lube light should go out just before you feel the clutch start to engage. If the low side is out you can leave it in high side but the dump valve still needs to be adjusted properly.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)