|
NEMO | Has the shift valve been checked? You can swap the CR valve with the C1, C2, C3 or C4 shift valve. If the problem follows the valve, then you've found the problem. The reverse valve is the furthest left of the 5 horizontal valves at the rear of the transmission. You may also want to check the large round connector under the front left corner of the cab for loose or corroded pins. It is the connector for the transmission harness. If all checks out ok, then an element pressure check should be performed to verify adequate pressure to the clutch element. Good luck. | |
|
JD 8410 TRANS NOT ALLOWING TO BACK-UP
