|
Iowa | Guessing it could be your master on/off valve needs to be adjusted. The ball is not seating properly and letting nh3 leak by then back into the 3/8 line that goes into the back of the inlet of the cooler and out the vapor lines. This would only happen if you have section valves ahead of you master on/ off. Check to make sure that the set screws are tight that hold the seam to the collar. Another Thing is that the internal seals in the cooler could be gone or bad and letting it leak by which then it would come out the vapor.
Edited by blackandyellow 4/13/2012 22:15
| |
|
Raven Question
