|
Queensland Australia | Hi all,
i have installed a topcon x20 auto steer on my jd4730 sprayer using the jd hyd valve & wheel angle sensor. I have done all the setup cal's & have it running pretty good except for 1 little problem, if i bring the machine onto the line & engauge autosteer it pulls off to the right of the line by about 8 inches for about 20 seconds & then goes back onto the line & stays there for the length of the run.
I thought it may have something to do with the WAS & have recalibrated it & played with WAS valve speed, but the problem persists.
Am i on the right track, or is there something else that i need to adjust?
Cheers 6mm | |
|