|
WC Indiana | I have a new Integra 3.1 with a Ravens flowmeter (710) gals, 168 NH3 pounds.
The rate controller is a Ravens fast Valve with an initial valve Cal of 743.
I understand that I should enter 71 for the flowmeter calibration (10% of the 710 gallons)?
1. In the controller type it has Direct Command or Flowmeter, what should I enter there? (It was set on direct command)
I set up the fast valve as an Inline servo with 40 valve 1,10 valve 2, and 5 response
Is the valve cal of 743 used anywhere in the Integra?
With these settings I only get on about 2/3 of desired rate. I upped the flowmeter to 90 and it is getting closer.
I would like to figure out why my numbers aren't working right. Rate is also constantly fluctuating from 90-250. Desired is 150.
| |
|
Raven 743 flow meter setting in Integra for NH3 flow meter calibration nubmer. ??
