|
![](/profile/get-photo.asp?memberid=3041&type=profile&rnd=92)
| I figured out what my problem was. Raven isn't consistant on how they want the offsets entered. The offsets to tell the cruizer where the planter is in relation to the receiver was a little confusing. In the offset menu under tools, when you put in your offset, it is in a positive number even though the planter is behind you. My situation the offset is 258 in. However, when you enter the same planter offset in the sections menu to set up the sections even though it is the same exact offset, you need to enter it in a neg. number or it will think the planter is 258 in. ahead of the tractor. Ie, there I had to put -258in. in that menu. Why they don't have
both of them either pos. or neg. I don't know. One of each was kinda confusing at first. It looks like it should work pretty good now.
Edited by sparrell 3/17/2012 19:00
| |
|