Just picked up our new rate controller and harnesses today. Got it all hooked up on my tractor with 2630 display. All I am going to use the controller for now is banding pre emerge behind our planter. The tractor is set up with a 300 gallon front tank with a hydraulic pump mounted on the tank frame, and Raven valves and flow meter mounted on the back. I set up all the valve cal. and I tried to manually turn the Valve section on and off with the 2630 on and engine off, but never could get it to respond.I also noticed when I set the controller for pull type sprayer there is no whisker switch setting, but there is for say liquid fert. application. Any pointers on how to set this up to work with our Kinze planter would be greatly appreciated. TIA