|
Butterfield, MN | You may have to play around with this a little bit to figure out the best way to do it in your fields, but if you have one straight side of the field, I'd recommend using this side to start with. Begin in straight A-B mode and record your A-B line as you drive along that first side. Once you've gotten to the bottom left corner of the sheet of paper and have your B point set, switch over to last pass mode. drive along the bottom, up the right side, and so forth until you get back to the starting point. If you want to make a second round around the field, you can keep going in last pass. Once you get back again, you can switch over to straight A-B mode again and go up and down the field. If you get over to the other side and have some odd shaped portions left, then switching back to last pass agian will help you do the most efficient coverage without running over the same thing over and over again. I'll second the boom sense adapter also. It is part number 115-0171-792. Go into the blue tools button on your home screen and change your "switch" setting from "touch screen" to "hardware". Plug the adapter into port B on the back and put 12 volts to it (probably from your master spray switch) and you're ready to roll. | |
|
Newbie Cruizer question
