|
| Thanks for reply. As you can see I'm still shopping. The super singles on the scraper tractor being narrower than pan makes sense now that you say it that way.
We were working on the problem with the hydraulic problem with the NH9680 today. We plumbed the hydraulic lines for the tilt and lift/tile feeder together into one set so that we only have to run 2 remotes at a time instead of three. This seemed to tremendously help out the problem but still only have 2450psi on grade cylinder. Also to get this we have to run the tractor at 1600 rpms and the ground speed on the tractor is 1.8mph at 1600rpms. So with marginal pressure and high speed I dont think its a good situation. Now were back to either power unit on plow and try to idle down tractor or different tractor. | |
|